Mailing Addr
ess: Shipping Address:
PO Box 1674
2666 S Country Club Rd
Warsaw, IN 46581-1674
Warsaw, IN 46580
Tools Needed for Assembly
-7/16” wrench (two)
Parts Shipped with Unit:
-Head
-Aluminum handle (not shown)
-Wrap-around brace (set of 2)
-Bolt bag for brace
-Rubber blade (one edge square, one edge either rounded or
slanted
Seal Coat Squeegee
Assembly Instructions
Rubber Blade Installation Instructions:
1.
Loosen nuts (do not remove) on head and insert square edge of rubbe
r
blade.
2.
Rest rounded or slanted edge of rubber blade on a hard, flat surfac
e (as
sho
wn) and adjust blade to ensure the square edge is seated straig
ht in the
head a
nd level with the flat surfac
e.
3.
Tighten nuts until rubber blade is secure, being carefu
l not to over tighten.
NOTE
: It is important when installing or replacing the rubber blade that it be
installed straight.
Handle & Brace Assembly:
1.
Slide slotted end of handle over center hole on alumin
um head.
2.
Align holes and insert middle si
ze bolt.
3.
Align holes of flat end of braces with holes on head, as shown, and
insert
the two sh
ortest bolts and nuts (do not tighten nuts un
til step 5)
4.
Align holes of wrap-around end of braces with the handle, as show
n, and
inse
rt the longest bolt an
d nut.
5.
Tighten all loc nuts on bolts. Use wrenches to tighten, being carefu
l not to
over tighten. Over tighteni
ng may result in crushing the han
dle, thereby
comp
romising its strength.
REPLACEMENT PARTS LIST
See Reverse Side
PK90292
01/21/15
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 844-SEYMOUR
FAX: 574-267-8508 ��
w
ww.seymourmidwest.com
Comentarios a estos manuales