Seymour-midwest Wire Gauge Rake(PK90113) Manual de usuario descargar pdf

Wire Gauge Rake

Assembly Instructions

Tools Needed for Assembly:

7/16” wrench (two)

Parts Shipped with Unit:

Head assembly (3 wires and hardware included)

Threaded handle adapter or aluminum handle (not pictured)

Gusset brace (set of 2 – one gusset is labeled)

Bolt bag for braces

Gusset Brace Instructions:

1. Slide slotted handle or threaded handle adapter over the center

hole on the aluminum frame.

2. Position labeled gusset on bottom of handle/adapter, and the

other

gusset

on top of the handle/adapter as shown.

3. Insert the two longest bolts through the top gusset,

the

hand

le/adapter and the bottom gusset. Insert the two shorter bolts

through the two remaining holes on the

frame.

4. Tighten

all nuts, being careful not to over-tighten. Over-tighte

ning

har

dware may result in crushing the handle, thereby compromisi

its

stre

ngth.

PK90113

01/21/15

To Adjust Coating Thickness:

1. Loosen all six wing nuts (B).

2. Slide gate (A) up or down to desired depth (C) and tighten two

outside wing nuts.

3. Ch

eck setting (C) again and tighten remaining wing nuts befor

usi

Note: This unit has been assembled at the factory for 0” to 3/8” thickness. To

obtain 13/32” to 5/8” maximum thickness, gate (A) should be removed and

turned upside down then re-installed as the adjustment slot is offset to one side.

REPLACEMENT PARTS LIST

See Reverse Side

Mailing Address: Shipping Address:

P.O. Box 1674 2666 S. Country Club Rd.

Warsaw, IN 46581-1674

Warsaw, IN 46580

FULL WARRANTY

All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.

Products which have been abused or worn out from normal use are excluded from this warranty.

We reserve the right to replace or issue credit on an individual basis.

Phone: 844-SEYMOUR

FAX: 574-267-8508 ��

www.seymourmidwest.com

1 2

Wire Gauge Rake 1
Gate – 14” 2

Indice de contenidos

Pagina 1 - Wire Gauge Rake

Wire Gauge Rake Assembly Instructions Tools Needed for Assembly:7/16” wrench (two) Parts Shipped with Unit:Head assembly (3 wires and hardware incl

Pagina 2 - Gate – 14”

WIRE GAUGE RAKE REPLACEMENT PARTS SP10127 Head – 14” SP30064 Gate – 14” SP10052 Head – 24” SP30040 Gate – 24” SP10049 Head – 36” SP300

Comentarios a estos manuales

Sin comentarios

Seymour-midwest Wire Gauge Rake(PK90113) Manual de usuario

Busca en linea o descarga Manual de usuario para Herramientas Seymour-midwest Wire Gauge Rake(PK90113). Seymour Midwest Wire Gauge Rake(PK90113) User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Seymour-midwest Wire Gauge Rake(PK90113)