Twist Brace
Assembly Instructions
Tools Needed for Assembly
- 7/16” wrench (two)
Parts Shipped with Unit:
- Head with riveted twist braces
- Bolt bag for brace
- Aluminum handle with cap (not shown)
Assembly Instructions for Handle:
1. Slide slotted end of ha
ndle over center hole on aluminum head.
2. Align holes and in
sert shorte
r bolt. Do not tighten until all
hard
ware is in plac
e.
Twist Brace Instructions:
1. Rotate en
ds of braces out to handle. Align holes
of
braces with the handle as shown, and insert the longer bolt.
2. Start both
loc nuts on bolts. Use wrenches to tight
en, being
careful not to over tighten. Over tightening may result in crushing
the handle, thereby compromising its strength.
Mailing Addr
ess: Shipping Address:
PO Box 1674
2666 S Country Club Rd
Warsaw, IN 46581-1674 Warsaw, IN 46580
REPLACEMENT PARTS LIST
See Reverse Side
PK90331
01/21/15
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 844-SEYMOUR
FAX: 574-267-8508 ��
www.seymourmidwest.com
Comentarios a estos manuales