Mailing Addr
ess: Shipping Address:
PO Box 1674
2666 S Country Club Rd
Warsaw, IN 46581-1674
Phone: 844-SEYMOUR
FAX: 574-267-8508
www.seymourmidwest.com
Warsaw, IN 46580
CAM
®
Gauge Rake
Assembly Instructions
Tools Needed for Assembly:
7/16” wrench (two
)
Parts Shippe
d with Unit:
Hea
d assembly
Threaded handle adapter or aluminum handle (not picture
d)
Gusset brace (set of 2) – one gusset is labeled
Bolt bag for br
aces
CAM
®
sets are ordered separately and may or may not be
shipped with this unit
Gusset Brace Instructions:
1.
Slide slotted handle or threaded handle adapter over the center
hole on the aluminum fram
e.
2.
Position labeled gusset on bottom of handle/adapter, a
nd the other
gusset on top
of the handle/adapter as
shown.
3.
Insert the two longest bolts through the top gu
sset, the
handl
e/adapter and the bottom gusset. Insert the two shorter bolts
through the two remaining holes o
n the frame.
4.
Tighten all nuts, being careful not to over-tighten. Over-tighten
ing
hard
ware may result in crushing the handle, thereby compromisi
ng
its strength.
CAM
Assembly:
1.
Remove the wing nut and loc washer on each end of
the head
assembly.
2.
Place the CAM
®
on the head, as shown, followed by the loc washer.
Secu
re with wing nut. Do the same on the opposite e
nd of the
head.
3.
Make sure CAM
®
striking surface is in line with screed edge, as
pictured
.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
REPLACEMENT PARTS LIST
See Reverse Side
PK90090
1/14/15
Comentarios a estos manuales